Wednesday, October 30, 2013

DIY Fabric Butterfly Cape

After having changed his mind at least four times, my son has finally decided that he wants to be a butterfly for Halloween.  Luckily, it wasn't too difficult to whip up a butterfly wing cape for his costume.





I began by taking measurements of his arm span and back neckline.  I used these to draw a half wing.

Free hand your pattern.  You can see mine is very rough.

I folded 1 1/2 yards of black cotton fabric in half and then in half again. Placing the half wing on the folded edges, I cut out the pattern.  This creates two sets of wings for the cape. One set will become the outside and the other the lining. 




Next, I free handed some shapes for the wing details.


I cut four of each shape from yellow and orange cotton fabric in order to cover the outside of the cape and the lining.



The middle section was a bit bare, so I cut two wedges from the yellow fabric.


When all of the pieces were cut, I pinned them to the wings.  As much as possible, I tried to make the pattern symmetrical on each side.


To install the applique, I chose to straight stitch around all of the edges.  If you have some time, you could do a zigzag stitch, which would keep the edges from fraying. You could also glue them on with fabric glue to save time.


Oops.  Don't make the same mistake I did and sew over the edge of the wing.

Once all the orange pieces were stitched on, I stitched on the yellow.



Whew!  It did take some time (and patience) to stitch on all 22 pieces.  But the finished result looked great.  It was now time to stitch the sides together, right sides facing. Leaving the collar open, I stitched around all of the edges. 

Now you can see why I wanted to add a lining.

Because there are points and curves, I snipped the outer edges about every two inches or so to allow for some flexibility.  I was careful not to cut the seam.

Snip into each peak, making sure not to cut the seam.
Next, I turned it right side out through the open collar.


Very carefully, I pushed out the edges while I ironed them flat.  Then I stitched around the outer edges, wrong sides facing.  Again, I kept the collar open.

Stitch around outer edges.  This helps the cape to lay flat.

Now for the collar.  I stitched white bias tape around the edges, leaving about a foot and a half on each side for ties.

Open one side of bias and stitch it onto the edges of the cape.

After one side of the bias was sewn, I flipped it over the edge of the collar to the other side and stitched it down.  This split the bias in half, so I stitched down to the end on both sides to make the ties.



At the end of the cape sleeve line, I added elastic bands.  This allows my son to flap his butterfly wings, as all two year olds love to do.


I wanted these wings to look a little more butterflyish, so I added white dots and black lines with multi-surface paint.


The cape was a huge success with my son and his adorable little friend.  They took turns wearing it and "flying" around.  So precious!






I loved making my son's Halloween costume this year.  What's your all-time favorite homemade costume?




12 comments:

  1. So cute and creative Trish! I think my favorite costume so far, was the one I made my daughter for Carnival in February. It was a refashioned sock monkey costume.I have guest posted about it a couple of days ago, and will bring it to my own blog in a few days time.

    ReplyDelete
    Replies
    1. Thanks for your sweet comment, Magda! Is the sock monkey costume posted yet? I can't wait to see it. I used to make sock creatures all the time. In fact, I'm going to have some tutorials coming up.

      Delete
  2. This is so adorable! Great job and I bet he will have so much fun trick or treating in it.

    ReplyDelete
    Replies
    1. Thank you, Sister! He did have a great time. So cute to watch him with his little friends.

      Delete
  3. Great costume and such cute children :) I really liked the addition of the fabric paint - it was the finishing touch.

    ReplyDelete
    Replies
    1. Hi Jenny. I really appreciate your comments! My little one and his friend had a blast "flying" around. It's such a cute age.

      Delete
  4. What a cute cape! It looks like you have the butterfly thing down now! Congratulations on a successful season of Refashion Runway. I thought that each of your refashions were wonderful and you looked so cute in them! I look forward to following you and seeing what you come up with next!

    ReplyDelete
    Replies
    1. Thanks, Susan! Yes, this year was all about butterflies - I think because we saw so many on our trip to Oklahoma. Congratulations to you as well. You really blew me away with your talent. I amazed at how you were able to add so much detail to your refashions.

      Delete
  5. Congratulations! I enjoyed watching all of your creations. what a talented seamstress you are. Loved the wings!

    ReplyDelete
    Replies
    1. Thank you for following and supporting all of us in the competition. I've really learned a lot from this experience.

      Delete
  6. Thank you for posting this! All the other sites I have looked at either want to be elusive about their creations or the design is too elaborate or too cheap looking or just not quite right. I always make things to add to my niece's dress-up treasure chest for her birthday each year and this year I wanted to add wings. I have seen these fabric wings and wanted a simple explanation on how to make them, just a little guidance. Her birthday is in 3 weeks so I am very glad to have have found your blog tonight! She will be three, these will be durable and make playtime extra fun! Thank you for sharing.

    ReplyDelete
    Replies
    1. I'm thrilled that you found the tutorial helpful. I'm sure your niece will love her new wings. I'd love to hear how they turned out.

      Delete

Thank you for sharing your thoughts!